Here are some point to set PEUGEOT 405 cylender head:

1.  Drain the engine oil and make sure that the water and oil passages in the cylinder block are free of any folds and pollution.

2.  When opening the cylinder head from the packing box, make sure that there is no impact or deformation on the cylinder head.

3. In preparing assembly parts on the cylinder head, it is necessary to be careful to use standard parts

   This company does not accept any responsibility for the use of non-standard parts

       4.The smoke and air valves must be of the standard type, and in terms of the correct assembly of the valve stem on the valve gate of the cylinder head, the necessary care must be taken. If you see any looseness or stiffness beyond the permissible limit, replace the valve.

Here are some things to briefly install the brake disc:

1.  Engrave the name of FGP on the piece.
2. Brake disc parts are made of cast iron and are not covered with paint and are sensitive to the humidity of the environment. Therefore, the possible observation of rust spots on the surface of the part is completely normal, because in the shortest possible time, its surface will suffer from surface rust at the place of installation. This rust is quite visible on the brake disc that you are going to replace.

Things you should pay attention to during installation to prevent the steering wheel from vibrating when braking:

Before installing new brake pad,check the old brake pad.

1-Before installing new brakepad,check the old brakepad.If uneven corrosion of pads and brake diskis observed,it should be checked and controlled.If the disk is wraped or distorted,replace the brake disk.

2-After removing the brake disk,the contact surface and edges of wheel hin must be completely de-rusted.Using a sutible tool(such as sand paper)

The points you should pay attention when buying and installing a water pump:

One of the important parts in the car engine is the waterpump,which has the task of pumping water in the engine,which prevent the car engine from overheating by constantly circulating water and antifreez in the engine.The waterpump cools the engine by pumping around the engine and cylenders,and this water returns to the radiator after being circulated by the waterpump.

The wheel hub facilitates the rotation of the wheels, connects the wheels to the car and transmits torque or power to the wheel. After the wheel is mounted on this piece and its two flanges and bearings are coupled with the hub, the wheel starts to rotate easily.